|
這個問題我來回答：
標準里是這樣說的 ：
2-461
• The mobile station shall cancel any remaining visits away from the Serving
1
Frequency in the current search period and shall not send a Candidate Frequency
2
Search Report Message for the current search period.
3
• The mobile station shall disable the periodic search timer.
4
• The mobile station may stop maintaining the average of the Serving Frequency
5
received power that is used in the handoff and search procedures.
6
2.6.6.2.11 Processing of Reverse Supplemental Code Channels and Reverse Supplemental
7
Channels
8
If USE_T_ADD_ABORTs is set to ‘1’, and the strength of a Neighbor Set or Remaining Set
9
pilotisfoundtobeaboveT_ADDs,thenthemobilestationshallterminateanyactive
10
transmission on Reverse Supplemental Code Channels or Reverse Supplemental Channels
11
at the end of the current 20 ms frame.The mobile station shall do the following:
12
• Any previously active Reverse Supplemental Code Channel or Reverse Supplemental
13
Channel assignment shall be considered implicitly terminated.
14
• If active transmission on Reverse Supplemental Code Channels is terminated, the
15
mobile station shall set NUM_REV_CODESs to ‘000’ and shall set IGNORE_SCAMs
16
to ‘1’.
17
• If active transmission on Reverse Supplemental Channels is terminated, the mobile
18
station shall set IGNORE_ESCAMs to ‘1’.
19
• The mobile station shall set SCRM_SEQ_NUMs to (SCRM_SEQ_NUMs + 1) mod 16.
20
• The mobile station shall transmit a Supplemental Channel Request Message with
21
USE_SCRM_SEQ_NUM set to ‘1’, SCRM_SEQ_NUM set to SCRM_SEQ_NUMs, and
22
SIZE_OF_REQ_BLOB set to ‘0000’.
23
2.6.6.2.12 Periodic Serving Frequency Pilot Report Procedure
24
WhilethemobilestationistunedtotheServingFrequency(specifiedbyCDMACHsand
25
CDMABANDs),Tthemobilestationshallcontinuouslymeasurethetotalreceivedpower
26
spectraldensity,inmW/1.23MHz,ontheServingFrequencyatleastonceevery20ms
27
frame. (0.02 seconds) and The mobile station shall maintain the average value of the total
28
receivedpowerspectraldensity,spec_density,overthelastN12mframes. Themobile
29
station shall maintain the PPSMM timer as follows:
30
• When the mobile station starts a Periodic Serving Frequency Pilot Report Procedure,
31
it shall set the PPSMM timer to PPSMM_PERIODs × 0.08 seconds and shall enable
32
the timer.
33
• When the PPSMM timer expires, the mobile station shall send a Periodic Pilot
34
Strength Measurement Message (2.6.6.2.5.2) to the base station, reset the PPSMM
35
timer to PPSMM_PERIODs × 0.08 seconds and shall re-enable the timer.
C.S0005-A-1
2-462
• When the mobile station receives an Extended Handoff Direction Message , a General
1
Handoff Direction Message or a Universal Handoff Direction Message directing the
2
mobile station to perform a hard handoff (see 2.6.6.2.5.1), it shall abort the Periodic
3
Serving Frequency Pilot Report Procedure and disable the PPSMM timer if it is
4
enabled.
5
• If MIN_PILOT_PWR_THRESHs is not equal to ‘11111’ and
6
MIN_PILOT_EC_IO_THRESHs is equal to ‘11111’, the mobile station shall perform
7
the following actions once per frame:
8
– Disable the PPSMM timer if the received total energy per PN chip, Ec, of the
9
pilots in the Active Set is not less than (-120 + 2 MIN_PILOT_PWR_THRESHs),
10
where the value of Ec is computed as 10 × log10 (PS × spec_density) and PS is
11
the total Ec/Io of the pilots in the Active Set measured as specified in 2.6.6.2.2.
12
– Reset the expiration time of the PPSMM timer to PPSMM_PERIODs × 0.08
13
seconds and re-enable the timer if the following conditions are true:
14
οthe PPSMM timer is disabled, and
15
οthe received total energy per PN chip, Ec, of the pilots in the Active Set is less
16
than (-120 + 2 × MIN_PILOT_PWR_THRESHs).
17
• If MIN_PILOT_PWR_THRESHs is equal to ‘11111’ and MIN_PILOT_EC_IO_THRESHs
18
is not equal to ‘11111’, the mobile station shall perform the following actions once
19
per frame:
20
– Disable the PPSMM timer if the total pilot strength of the pilots in the Active Set,
21
PS, satisfies the condition that (-20 × log10(PS)) is not greater than
22
MIN_PILOT_EC_IO_THRESHs.
23
– Reset the expiration time of the PPSMM timer to PPSMM_PERIODs × 0.08
24
seconds and re-enable the timer if the following conditions are true:
25
οthe PPSMM timer is disabled, and
26
οthe total pilot strength of the pilots in the Active Set, PS, satisfies the
27
condition that (-20 × log10(PS)) is greater than MIN_PILOT_EC_IO_THRESHs.
28
• If MIN_PILOT_PWR_THRESHs is not equal to ‘11111’ and
29
MIN_PILOT_EC_IO_THRESHs is not equal to ‘11111’, the mobile station shall
30
perform the following actions once per frame:
31
– Disable the PPSMM timer if the following conditions are true:
32
οthe received total energy per PN chip, Ec, of the pilots in the Active Set is not
33
less than (-120 + 2 × MIN_PILOT_PWR_THRESHs), and
34
οthe total pilot strength of the pilots in the Active Set, PS, satisfies the
35
condition that (-20 × log10(PS)) is not greater than
36
MIN_PILOT_EC_IO_THRESHs.
37
– Reset the expiration time of the PPSMM timer to PPSMM_PERIODs × 0.08
38
seconds and re-enable the timer if the following conditions are true:
39
C.S0005-A-1
2-463
οthe PPSMM timer is disabled, and
1
οthe received total energy per PN chip, Ec, of the pilots in the Active Set is less
2
than (-120 + 2 × MIN_PILOT_PWR_THRESHs), or the total pilot strength of
3
the pilots in the Active Set, PS, satisfies the condition that (-20 × log10(PS)) is
4
greater than MIN_PILOT_EC_IO_THRESHs.
5
• If MIN_PILOT_PWR_THRESHs is equal to ‘11111’ and MIN_PILOT_EC_IO_THRESHs
6
is equal to ‘11111’, the mobile station shall maintain the PPSMM timer independent
7
of the received power and the total Ec/Io of the pilots.
不多說了我們大家可以這樣理解：一般現在廠家有些做跨頻切換時候或其他硬切換的時候會采用這條消息并且設置TIME=PPSMM_PERIODs × 0.08 seconds
|
關注樓主