【資料名稱】：NSNWCDMAwirelessparametersconfigurationV

【資料作者】：無(wú)

【資料日期】：2011-1-3

【資料語(yǔ)言】：英文

【資料格式】：DOC

【資料目錄和簡(jiǎn)介】：

"This parameter defines the maximum number of ""in sync"" indications received from L1 during the establishment of a physical channel (UE counter used in idle mode).
When a physical dedicated channel establishment is initiated by the UE, the UE starts a timer T312 and wait for layer 1 to indicate N312 ""in sync"" indications. On receiving N312 ""in sync"" indications, the physical channel is considered established and the timer T312 is stopped and reset.
If the timer T312 expires before the physical channel is established, the UE considers this as a ""physical channel failure""."
This parameter defines the maximum number of successive "out of sync" indications received from L1 (MS counter).
This parameter defines the maximum number of successive "in sync" indications received from L1 while T313 is being activated (UE counter).
The maximum number of preambles allowed in one preamble ramping cycle. PRACH Preamble Retrans Max is part of "PRACH power offset" which is part of "PRACH system information list" which is part of System Information Block 5&6.
"Tcell of WCEL - Primary downlink scrambling code and Frame timing offset of a cell combination must be unique within WBTS.
UARFCN of WCEL - Primary downlink scrambling code and UTRA Absolute Radio Frequency Channel Number combination must be unique within WBTS"
Defines the noise level in the BTS digital receiver when there is no load (thermal noise + noise figure). This parameter is needed in noise rise calculations.