【資料名稱】：APG40 Check list for new node installation

【資料作者】：愛立信

【資料日期】：2008

【資料語言】：英文

【資料格式】：DOC

【資料目錄和簡介】：

1Information
•This check list is use for all type of APG40 nodes installed
2APG40 Check list for "Factory Start Up and Test of APG40 – Windows NT and Windows Server 2003”


Contents
1Information1
2APG40 Check list for "Factory Start Up and Test of APG40 – Windows NT and Windows Server 2003”1
2.1Description3
2.2Installation test information3
2.3Check responsible3
2.4Node information4
2.5Initial check and backup after powered on4
2.6Set site parameter5
2.7Time zone and account check6
2.8【Stress Test】Raiddisk stress test and check APG40C/27
2.9【Stress Test】Shutdown both nodes and power cycle7
3DHCP setting for APZ 212 40 for AP17
4DHCP setting for APZ 212 50 for AP19
5DHCP/TFTP setting for all APZ types for AP110
6APG40 Basic function check10
7Set parameter for IO node (AP1)11
8Set virtual directory12
8.1User settings13
9Check list for “FACTORY NE TEST OF APG40 WINDOWS NT and WINDOWS SERVER 2003”13
9.1APM function check13
9.2APIO function check on AP1.13
9.3External alarm function check13
9.4Alarm panel test13
9.5Fan test (BFD 609 08/3)13
9.6IPN test. (APZ 2123x)14
9.7Check AP-CP communication14
9.8AP backup and verify test14
9.9DAT backup transfer test14
9.10Check FTP function14
9.11Backup restore from DAT tape and restore test14
9.12Final SW level14
10Additional Settings.Specific for Japan networks15
11Note:18
12Appendix1: Disk capacity19
12.1【CM3xx】HLR/FNR IO Node (AP1)19
12.2【CM3xx】MSC IO Node (AP1)20
12.3【CM3xx】MSC CDR Node (AP2)21
12.4【CM013 or higher APG40C/2】HLR/FNR IO Node (AP1)22
12.5【CM013 or higher APG40C/2】HLR/FNR/MSC IO Node (AP1)23
12.6【CM013 or higher APG40C/2】MSC CDR Node (AP2)24
12.7【CM013 or higher APG40C/4】HLR/FNR/MSC IO Node (AP1)25
12.8【CM013 or higher APG40C/4】MSC CDR Node (AP2)26
13Appendix 2 User settings27
13.1【CM3xx】HLR/FNR/MSC IO Node (AP1)27
13.2【CM3xx】MSC CDR Node (AP2)29
13.3【CM013 or higher APG40C/2】HLR/FNR/MSC IO Node (AP1)30
13.4【CM013 or higher APG40C/2】MSC CDR Node (AP2)32
13.5【CM013 or higher APG40C/4】HLR/FNR/MSC IO Node (AP1)34
13.6【CM013 or higher APG40C/4】MSC CDR Node (AP2)36
14Revision information38
15Reference38

[ 本帖最后由 laomaoyixin 于 2011-5-12 21:24 編輯 ]