【資料名稱】：bsc出現(xiàn)bpc　fail處理流程

【資料作者】：路人甲

【資料日期】：09-29

【資料語言】：英文

【資料格式】：DOC

【資料目錄和簡介】：

After IPA9 loading,we should check if any BPC failed existed.

* RXCDP:MO=RXOTG-;To checkisBCCH can not configured with BPC fail


<RXCDp:mo=RXOTG-44;
RADIO X-CEIVER ADMINISTRATION
MANAGED OBJECT CONFIGURATION DATA

MORESULTARFCNMISMATCH
RXORX-44-0 CONFIGHOP NONE
RXORX-44-1 CONFIGHOP NONE
RXORX-44-2 CONFIGHOP NONE

MORESULTARFCNTXADTNBPC CHCOMBOFFSXRAICM
RXOTS-44-0-0BPCFAIL
RXOTS-44-0-1CONFIG66 0 214969CCCH 0NOON

* ALLIP:ACL=O1; To check if below alarm occoured

O1/APT "SZEB103R12/ME/G" 523 1108160040
CELL RF OUTPUT POWER SUPERVISION
CELLCHGRREASON
D5360BNO TRAFFIC

If the problem is initiated,TG forlopp release can fix it.


*. Locate the fault suspected TG.

RXTCP:CELL= ,MOTY=RXOTG;

*. Print the MO data for the TG.
The printout from RXMOP contains the TGFID.
RXMOP:MO=RXOTG-X;



*. Print the forlopp individuals for the TG-FID:
SYFIP:FID=H'E2-H'A; (Note that H' is needed in both parts of the FID)
In a TG-FID there should be hundreds of individuals.

Ex.
BLOCK FILENUMBERINDIVIDUALSTATUSFID-VAR
:
RCC H'0001H'0000 1D20ACTIVE2H'002E
:

*. Pick any of the active individualsand use that in the
forlopp release command:
SYFRI:FID=H'E2-H'A,BLOCK=RCC,FILENUM=H'0001,IND=H'1D20;
如：

*. The TG will now have a new TGFID connected to it (RXMOP) and the old
TGFID will say ABORTED (SYFIP).
Depending on the size of the BSC and CP load it will take a few minutes
until the new TG-FID is fully configured.
It is easy to check if the BTS is reconfigured with these commands:
RXCDP:MO=RXOTG-x;
RLCRP:CELL=cell;