小弟最近在BSC調測，由于改IP后出了很多問題，所以只能克隆

小弟有幾個疑問想請教各位大神

1.APG43克隆流程見附件，數據盤需要清空，系統盤DISK0需要清空嗎？ 注：流程上說除WINPE盤不清以外，其他disk0,1,2都需要clean.
現在小弟已經把A邊情況了。

2.上傳完克隆包以后，下一步是確認NTSERV盤盤符，我的盤符顯示大致如下
B邊
volume 0CNTBOOT
volume 1DNTSERV
volume 2ENTBACKUP
volume 3FNTDUMP
volume 4GWINPE

A邊
volume 0GDVD
volume 1HNTBOOT
volume 2FNTSERV
volume 3ENTBACKUP
volume 4DNTDUMP
volume 5CWINPE
所以詢問，需要把NTSERV設置為C盤嗎？
官方流程如下：

2 Start diskpart and check all volumes
x:\windows\system32\>diskpart
DISKPART>list volume
Volume Ltr Label Fs Type Size Status Info
------ --- -------- ----- -------- -------- ------ ----
Volume 0 Mirror 136 GB Healthy
Volume 1 Mirror 502 MB Healthy
Volume 2 G DVD-ROM 0 B Healthy
Volume 3 X WINPE FAT Partition 486 MB Healthy Boot
Volume 4 D NTBOOT NTFS Partition 5240 MB Healthy
Volume 5 C NTSERV NTFS Partition 20 GB Healthy
Volume 6 E NTBACKUP NTFS Partition 20 GB Healthy
Volume 7 F NTDUMP NTFS Partition 22 GB Healthy
3 Point to the NTSERV Volume and go to the following directory as in the
example below:
DISKPART>exit
cd /D C:\Program Files\AP\APOS\clone
NOTE: The NTSERV drive letter can be different from C.
Go to step 5.
If no drive letter is assigned to NTSERV partition, assign it performing the
procedure described in next step 4.
4 Assign drive letter to NTSERV
 start diskpart (command: diskpart)
x:\windows\system32\>diskpart
 Check which number NTSERV (specified in list volume printout)
partition has (let’s assume n).
 Select the volume (command: select volume n)
DISKPART>select volume <Volume No.>
 Assign a letter to the NTSERV drive (e.g. assign letter C
DISKPART>assign letter c:
 Exit diskpart (Command: exit).
DISKPART>exit
Note: Use command vol to check if connected to the right disk partition.
5 Run ConfigMenu.exe :
C:\Program Files\AP\APOS\clone>ConfigMenu.exe /preconfig

在第三步有這么一句話NOTE: The NTSERV drive letter can be different from C.
是需要把NTSERV改成C盤以后，再到第五步呢還是直接跳到第五步？

如果需要修改的話是只需要把NTSERV修改為C盤呢 還是按照C為NTSERVD為NTBACKUPE為NTBOOTF為NTDUMPX為winpe



急求各位大神指點，在線等。