【資料名稱】：Factory NE Test of APG43.Rev.L

【資料作者】：愛立信

【資料日期】：2010

【資料語言】：英文

【資料格式】：PDF

【資料目錄和簡介】：

Contents
1 Introduction 3
1.1 Concerned Hardware 3
2 Range of Test 4
2.1 Work Flow 4
2.2 Typographic Convention 5
3 Conditions before Starting 5
3.1 General 5
3.2 Supported APZ Source Systems 6
4 Test Tools 6
5 General 7
5.1 Schematic Overview – APG43 8
5.2 APG43 Front Side 10
5.2.1 BSC Board Configuration with APZ 212 55 10
5.2.2 CN Board Configuration with APZ 212 55 11
5.2.3 CN Board Configuration with APZ 212 60 12
5.2.4 Board Configuration with APZ 212 3x 13
5.3 Board Information of eGEM with APG43 and APZ 212 55 14
5.4 APG43 Architecture 16
5.5 APG43 Cabling for Magazine with APZ 212 55 17
5.6 APG43 Cabling for Magazine with APZ 212 60 18
5.7 APG43 Cabling towards Magazine with APZ 212 3x 19
6 Method 19
6.1 Preparation 19
6.1.1 Cabling 19
6.1.2 Alarm Connections 20
6.1.3 Power Up 20
6.1.4 Connect to the APG43 20
6.2 Check of Data 20
6.3 Check TYPE for SCB-RP 22
6.4 Test of APG43 23
6.4.1 Test when only APM SW is Installed and Active 23
6.4.2 Test when also APIO SW and STS SW are Installed and Active 24
6.5 Start Up and Test of External Alarm System 27
6.6 Test of Alarm Panel and Circuits 30
6.7 FAN Test for BFD 509 08/6 32
6.8 Test of IO Device 33
6.9 Configuration Change for the SSU Folder 34
6.10 Backup of APG43 SW and Transfer to DVD 35
6.11 SFTP Verification 38
6.12 Restore of APG43 SW from DVD 40
6.13 Audit Script 44
7 Helpful Hints 45
7.1 Using Remote Desktop 45
7.2 Exchange Data 45
7.2.1 Spontaneous Printouts 45
7.2.2 Routing of Alarm Printouts 46
7.2.3 Configuration of Alarm Printer 47
7.2.4 Heartbeat Configuration in APIO 47
7.2.5 External Alarm 47
7.2.6 Port Definition 47
7.3 References 48
8 Revision Information 51
9 Glossary 52
9.1 Terminology 52
9.2 Abbreviations 53