| 告警內容 | 告警大意 |
| BSC-TRANS [101] AIS [1] | 2M信號丟失 |
| BSC-TRANS [101] RAI [5] | 2M信號丟失 |
| BTS-EXTERNAL [9] Door-Window-Alarm-3[3] | 干接點3告警——門禁 |
| BTS-EXTERNAL [9] Air-Condition-7[7] | 干接點7告警——未定義 |
| BTS-EXTERNAL ******************* | 凡是BTS-EXTERNAL開頭的都為干接點告警 |
| ENVIR [5] HW-DEGRADED [237] | 環境 硬件降級 |
| RX-TX [10] HW-DEGRADED [237] | 硬件收發降級 |
| RX-TX [10] HW-FAILURE [239] | 硬件收發損壞 |
| RX-TX [10] TRE-VSWR [10] | 載頻駐波比 |
| CELL [43] LOSS-OF-TCH [2] | 小區TCH信道丟失 |
| BSC-TRANS [101] BER-10E-6 [7] | BSC收到10E-6次方誤碼 |
| BTS-TRANS [11] BER-10E-4 [102] | BTS收到10E-4次方誤碼 |
| RX-TX [10] ANTENNA-VSWR-WARNING [11] | 輕微駐波比 |
| BSC-TRANS [101] BER-10E-4 [6] | BSC收到10E-4次方誤碼 |
| SW-AN [3] WRONG-CONFIGURATION [14] | 合路器軟件配置錯誤 |
| BSC-TRANS ******** | 凡是BSC-TRANS 都是傳輸2M故障 |
| BTS-TRANS ******** | 凡是BTS-TRANS 都是傳輸2M故障 |
| BTS-POOL [54] EXTRA-TS-NOT-FULLY-USABLE [1] | 時隙不完全可用 |
| BTS-TRANS [11] TWO-MB-MISSING [50] | 2M信號丟失 |
| Hardware audit failed | 硬件同步失敗 |
| ENVIR [5] MAINS-AL [20] | 外接電源告警 |
| ENVIR [5] HW-FAILURE [239] | 環境硬件損壞 |
| CELL [43] LOSS-OF-SDCCH [1] | 小區SDCCH信道丟失 |
| CELL [43] LOSS-OF-BCCH [1] | 小區BCCH信道丟失 |
| ENVIR [5] SUBRACK-POWER [24] | 環境 機箱電源告警 |
| BTS-OM [44] AUDIT-FAIL [0] | 操作維護單元同步失敗 |
| BTS-TRANS [11] FAR-END-ALARM [176] | BTS傳輸遠端告警 |
| SW-AN [3] TELECOM-CONFIG-FAIL [13] | 電訊軟件配置失敗 |
| RX-TX [10] RX-CABLE [3] | 射頻線告警 |
| RX-TX [10] MODULE-NOT-PRESENT [51] | 模塊不在位 |
| RX-TX [10] MODULE-CLOCK-SIGNAL [22] | 時鐘模塊告警 |
| |
| by:qj_faq110 |
[tr][/tr][tr][/tr]
關注樓主