GPRSPRIO GPRS priority
This exchange property controls whether on-demand PDCHs will be treated as idle or busy for dynamic HR allocation and TCH packing functions (that is HR packing and DYMA), Cell Load Sharing, Subcell Load Distribution and GSM - UMTS Cell Reselection and Handover.
The variable consists of 16 bits, however only 4 of them have significance, the rest is always 0.
Bits B0, B1, B2, and B5, specify the priority between GPRS and the CS network for the three load regulation functions (see below).
The significant bits are defined as follows:
B0 - Dynamic HR allocation and HR packing priority
B1 - Cell Load Sharing priority
B2 - Subcell Load Distribution priority
B3 - Spare
B4 - Spare
B5 - GSM - UMTS Cell Reselection and Handover
Note: If pre-emption is restricted by exchange property PDCHPREEMPT, it is recommended to set B0, B1, B2, and B5 equal to 1 to achieve a better result from the corresponding load regulation functions.
Property type: Optional
The value is given as a decimal number, where only the significant bits (0,1,2,5) are taken in consideration. Bit value has the following meaning:
0 Allocated on-demand PDCH will be counted as idle Traffic Channel Full Rate (TCH/F) when traffic load is calculated in the cell.
1 Allocated on-demand PDCH will be counted as busy TCH/F when traffic load is calculated in the cell.
Default value: 0 for all bits
This exchange property is owned by the blocks RNLCT and RNTCH.
那么有這么一道題目：
384.有關GPRSPRIO，以下說法正確的是： AC
A: GPRSPRIO=0，計算半速率以及CELL LOAD SHARING時ON-DEMAND PDCH均作為IDLE的 TCH/F；00
B: GPRSPRIO=1，計算半速率以及CELL LOAD SHARING時ON-DEMAND PDCH均作為BUSY的 TCH/F；01
C: GPRSPRIO=2，計算半速率時ON-DEMAND PDCH作為BUSY的 TCH/F，而計算CELL LOAD SHARING時ON-DEMAND PDCH作為IDLE的TCH/F。 10
D：GPRSPRIO=3，計算半速率時ON-DEMAND PDCH作為BUSY的 TCH/F，而計算CELL LOAD SHARING時ON-DEMAND PDCH作為IDLE的TCH/F。 11

我想問的就是gprsprio答案c好像是錯誤的，10，1是b0位置還是b1位置
如果是b0位置就是對的。
請各位指教。